A lot of “roof inspections” in Southwest Florida happen without anyone touching the roof. A truck pulls up somewhere in Cape Coral, Fort Myers, Naples or Punta Gorda, someone walks the yard with a clipboard or flies a drone for ten minutes, and you get a quote. Sometimes a big one.
That is not a roof inspection. It’s an estimate with a drive-by attached.
A roof fails at its details: the flashing around a vent, a cracked pipe boot, a soft spot in the decking, a tile that slid an inch after the last storm. None of those show up from the driveway, and most don’t show up on a drone photo either. The only way to know what’s going on with your roof is for a trained person to get on it and look, and feel, and sometimes pry. And then climb into the attic and look at it from underneath.
Here’s what a real roof inspection in Southwest Florida should include, why the attic is part of it, and how to tell whether you got one.
What a drone or driveway roof inspection misses
A camera sees surfaces. A roof fails underneath them, and at the seams between them. These are the problems that a driveway or drone-only roof inspection routinely misses:
- Soft decking. Rotted or delaminated plywood under the shingles or tile feels spongy underfoot. It looks completely normal from above. This is the single most expensive thing to discover after the contract is signed, because it changes the scope of the job.
- Lifted or unsealed shingles. A shingle whose adhesive strip has let go lies flat and looks fine until a tropical-storm gust gets under it. You find it by lifting the edge with your hand, not by looking at it.
- Cracked or dried-out pipe boots. The rubber collar around every plumbing vent on your roof bakes in the Florida sun and splits after 10 to 15 years. The crack is on the uphill side, an inch wide, and invisible from 30 feet away. It’s one of the most common leak sources we find.
- Failed sealant and flashing. Caulk around flashing, skylights and satellite mounts shrinks and separates. You check it by touching it. On a photo it just looks like a dark line.
- Slipped or cracked tile. On a tile roof, the tile is not the waterproofing. The underlayment beneath it is. A tile that slid an inch exposes the underlayment to sun and rain. From the yard it looks like a slightly uneven line. Up close you can see the underlayment and whether it’s already deteriorating.
- Nail pops and exposed fasteners. A nail backing out lifts the shingle above it just enough to let water in, and not nearly enough for a camera to catch.
- Debris in valleys and behind chimneys. Leaf piles hold water against the roof. What’s under them, usually, is the worst section of the roof. Nobody moves debris from a drone.
This isn’t a knock on home inspectors, either. Their own industry standard says so. The InterNACHI Standards of Practice have the inspector check the roof “from ground level or the eaves” and state the inspector is “not required to walk on any roof surface” or “confirm proper fastening or installation of any roof-covering material.” That’s a reasonable standard for a general home inspection. It is not a roof inspection, and homeowners who think their home inspection covered the roof often find out otherwise during the first summer of storms.
What a real roof inspection should include, step by step
A proper roof inspection takes longer than ten minutes and involves a ladder. Here’s the sequence a trained roofer follows:
- Walk the perimeter first. Check the fascia, soffits, drip edge and gutters from the ground for staining, sagging or separation. Water stains on the soffit tell you where a leak has been running before you ever go up.
- Get on the roof. Walk every accessible slope, not just the one facing the street. Feel for soft spots in the decking. Note the pitch, the material, the approximate age and the number of layers.
- Check every penetration by hand. Every pipe boot, vent, skylight, satellite mount and chimney gets touched. Press the sealant. Lift the flashing edge. Look for cracks in the boot collar.
- Check the field. On shingle: lift edges to test the seal, look for granule loss, cupping, cracking and exposed nail heads. On tile: look for cracked, slipped or missing tile, check the ridge and hip mortar or foam, and look at the exposed underlayment at the eaves and valleys. On metal: check fastener seals, panel seams and rust at cut edges.
- Clear and check the valleys. Move debris. Valleys carry the most water on the roof, and what’s under the leaf pile is usually the worst section.
- Look in the attic if there’s access. Water stains on the underside of the decking, daylight through the roof, wet insulation, and rusted nail tips all tell you things the top side can’t. This is also where you confirm the ventilation is actually working.
- Photograph everything. Not a drone shot of the whole roof. Close-ups of every problem found, so the homeowner can see exactly what they’re paying to fix, and exactly what they aren’t.
- Sit down and go through it. Findings first, then options, then the estimate. A homeowner should never get a number before they’ve seen the pictures that justify it.
If the person who inspected your roof skipped steps 2 through 6, you got a quote, not a roof inspection.
Why a roof inspection should include the attic
The top of your roof tells you what’s wrong with it. The underside tells you what it’s already done to your house. A roofer who skips the attic is only seeing half the picture, and it’s usually the half that costs you less.
Here’s what the attic shows that the roof can’t:
- Where the water is actually going. A leak almost never shows up on your ceiling directly below where it enters the roof. Water runs down the underside of the decking and along rafters and trusses before it drips. From the attic, you can follow the stain trail back uphill to the real entry point. From the roof alone, you’re guessing.
- Old leaks that haven’t reached the ceiling yet. Dark staining on the underside of the plywood, rust on the nail tips, and compressed or discolored insulation are all leaks in progress. They can run for a season or two before the drywall gives it away. Catching one here is the difference between a small roof repair and a new ceiling, wet insulation and a mold problem.
- Daylight. With the lights off, any gap at a vent, a missing shingle or a cracked tile shows up as a pinhole of sun. It’s the fastest leak test there is, and you can only do it from inside.
- Whether the leak is even a roof leak. In Southwest Florida, a lot of “roof leaks” aren’t. Air handlers and duct lines in a hot attic sweat in our humidity, and the condensation drips onto drywall and looks exactly like a roof leak from your living room. A roofer who never goes in the attic will sell you a roof repair for an AC problem. One who does will tell you to call your HVAC company instead.
- Ventilation. Soffit vents blocked by insulation, bathroom exhaust fans dumping into the attic instead of outside, and ridge vents that aren’t actually cut through all show up here. Poor ventilation cooks your shingles from underneath and shortens your roof’s life. It also drives up your cooling bill.
- The condition of the structure. Decking that’s delaminating, trusses with water damage, and previous repairs nobody told you about are all visible from below.
Not every attic can be entered. Some have no hatch, some have too little clearance, and some have blown-in insulation deep enough that walking it would do damage. A good roofer tells you that plainly and inspects what can be seen from the hatch with a flashlight. What a good roofer doesn’t do is skip it without mentioning it.
For leaks that keep coming back after previous repairs, or water stains with no obvious source, we also offer thermal imaging roof inspections, which can show trapped moisture and wet insulation that a flashlight can’t.
When a drone roof inspection is legitimate, and when it’s an excuse
We’re not anti-drone. We use cameras and photos on every job. There are real situations where a roofer should not walk a roof:
- Steep pitch. Above a certain slope, walking without rigging is a safety issue, and a company that puts a worker up there anyway has a different problem.
- Fragile or very old tile. Some clay and concrete tile, especially older barrel tile, can crack under foot traffic if you don’t know where to step. An experienced roofer knows how to walk tile. An inexperienced one shouldn’t try.
- Active storm damage or structural concern. If the decking may be compromised, you assess from the ladder and the attic first.
- Wet or hot surfaces. A metal roof at noon in July, or any roof right after rain, waits.
In those cases, the right answer is a ladder inspection at the eaves, a thorough attic inspection, and drone or pole-camera photos to supplement, with the roofer telling you plainly that the roof wasn’t walked and why.
Here’s the difference. A legitimate reason is specific to your roof and gets explained to you. An excuse is a company policy. If a roofer never walks any roof, on any house, in any condition, that isn’t caution. It’s a business model built on speed: more “inspections” per day, more quotes out the door, and the real condition of your roof discovered by the crew on install day, when the price can only go one direction.
Why roof inspections matter more in Southwest Florida
A roof in Ohio can carry a cracked pipe boot for two years before anyone notices. A roof in Lee County gets tested every afternoon from June to October, and then tested for real when a named storm comes through.
Three things make a hands-on roof inspection more important here than almost anywhere:
Wind-driven rain finds everything. Normal rain falls down. Hurricane rain travels sideways, uphill and under things. A lifted shingle edge or a hairline gap in flashing that would never leak in a regular storm becomes a leak when water is being pushed at it horizontally for six hours. The small stuff a drone misses is exactly the stuff a hurricane finds.
Heat and UV age the details faster than the roof. Our sun destroys sealant, rubber boots and asphalt faster than it destroys shingles or tile. That means the parts of the roof most likely to fail are the small parts, the ones you have to be on the roof to check. A roof can have 10 good years left in the field and be leaking at every penetration.
Your insurance may depend on an inspection. Under Florida Statute 627.7011, once a roof reaches 15 years old, an insurer can decline to renew unless an inspection shows the roof has at least five years of useful life remaining. We covered the details in Is Your Roof Too Old to Insure in Florida? The short version: that inspection is the difference between keeping your policy and shopping for a new one in a hard market, and you want to know what the inspector is going to find before they find it.
The roofs that leak after a storm aren’t always the oldest ones. Very often they’re the ones where nobody checked the details.
How to tell whether you got a real roof inspection
You don’t have to climb up there yourself to know. Ask these questions, and look at what you were handed.
Did they bring a ladder, and did they use it? If the ladder never came off the truck, the roof wasn’t walked. Simple as that.
How long were they on the roof? Ten minutes on a 2,500 square foot home isn’t an inspection. It’s a look.
Can you see the problems in the photos? You should be able to point to a specific picture for every line on the estimate. “Flashing repair, $X” should come with a close-up of the flashing that’s failing. If the only photos are wide drone shots of the whole roof, the estimate isn’t tied to anything.
Did they tell you what’s fine? A real inspection reports the good along with the bad. A roofer who found nothing right about your roof is either looking at a roof that genuinely needs replacing, or looking for a sale.
Was the attic checked? If there’s attic access and nobody opened it, a major part of the inspection was skipped.
Did they explain it to you, or just leave a number? The findings come first. Then the options. Then the price. A quote handed over without a walkthrough of what’s wrong is a quote you can’t evaluate.
Will they put it in writing? Ask for the report, not just the estimate. A roofer who did the work has no reason not to give it to you.
How Giza does roof inspections in Cape Coral, Fort Myers, Naples and Punta Gorda
Every roof inspection we do, a sales associate gets on your roof. Not a drone operator in the yard. A person, on the roof, checking the penetrations and the valleys and the decking by hand, and photographing what they find. If your attic is accessible, we go in there too, because that’s where the leaks that haven’t reached your ceiling yet are hiding.
If you’re home, you get the findings, the photos and a written estimate before we leave your driveway. If you’re not, you get the detailed report and estimate the same day. Either way, you see the pictures before you see the price, and the inspection is free.
Sometimes what we find is that your roof is in good shape and needs a couple of pipe boots and some sealant. We’ll tell you that. A company that gets on roofs can afford to be honest about the ones that don’t need a roof replacement, because it isn’t guessing.
For homeowners who’d rather not think about their roof until something goes wrong, that’s what Giza Shield is for. It’s our roof care membership: scheduled inspections that catch the small problems, the cracked boot, the lifted shingle, the slipped tile, before the next storm turns them into a ceiling stain. Protected by Giza Roofing Solutions means someone is actually looking.
Roof inspection FAQs
How often should a roof be inspected in Southwest Florida?
Once a year at minimum, and after any named storm that passes through Charlotte, Lee or Collier County. If your roof is approaching 15 years old, get it inspected before your insurance renewal, not after the non-renewal letter arrives.
Is a roof inspection free?
Ours is. Giza Roofing Solutions does not charge for a roof inspection or the written estimate that comes with it, anywhere in Charlotte, Lee and Collier counties.
Does a roof inspection include the attic?
It should. We check the attic on every inspection where there is safe access, because leaks show up underneath the decking long before they show up on your ceiling.
How long does a roof inspection take?
Long enough to walk every accessible slope, touch every penetration and look in the attic. Size and complexity change the time. If someone finished in ten minutes without a ladder, you got a look, not an inspection.
Can a roof inspection help with my homeowner’s insurance?
Indirectly, yes. The roof condition form your insurer wants has to come from an inspector your insurer accepts. Our inspection tells you what that inspector is going to find, what’s worth fixing first, and whether the roof realistically has the five years of remaining life Florida law requires for a roof 15 years or older.
Schedule a free roof inspection in Charlotte, Lee or Collier County
If your roof hasn’t been walked in the last year, or if the last “inspection” you got happened from the driveway, let us take a real look. We serve Cape Coral, Fort Myers, North Fort Myers, Lehigh Acres, Estero, Bonita Springs, Naples, Punta Gorda, Port Charlotte and everywhere else in Charlotte, Lee and Collier counties. The inspection is free, you’ll see every photo, and you’ll have a written estimate the same day.
If you’ve already got a quote from someone who never left the ground, bring it. We’ll get on the roof and tell you what they missed, or tell you they got it right.
Schedule your free roof inspection